XRAY 303091 Ultra-Tune Rear Shock Tower 2.5 mm  [XR-303091]

XRAY 303091 Ultra-tune Shock Tower Rear - 2.5 mm Graphite
Price:
£27.37
Brand:
XRAY
Model:
XR-303091
Condition:
Brand New
Write a review

Graphite Rear Shock Tower for Accurate Setup Work

The XRAY 303091 Ultra-Tune Shock Tower Rear uses 2.5 mm graphite to give vintage T Series cars a firmer rear mounting point. This increases setup accuracy and supports repeatable handling characteristics for competitive runs.

Material Benefits for Rear End Behaviour

Graphite delivers a useful mix of low mass and stiffness that improves tyre contact predictability. The XRAY 303091 helps reduce unwanted chassis movement so drivers can apply tighter setup changes with confidence.

Suitability and Fitment Advice

Specifically produced for older T Series variants, this tower is a good match for restorations and performance upgrades. Verify alignment and clearances during fitment to avoid interference with shocks or bodywork.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I retrofit this to later T Series versions?

Later variants may have differing hole patterns. Compare your chassis layout to the tower before purchasing to confirm compatibility.

How does this affect mid-corner balance?

Increased rear stiffness gives a more neutral mid-corner balance and can reduce oversteer caused by excess rear flex. Fine-tuning of anti-roll and shock settings may still be required.

Are any upgrades recommended alongside this tower?

Consider fresh shock mounts, updated bushings and quality fasteners to get the best performance and secure fit with the new tower.

What maintenance should I schedule?

Regularly check for hairline cracks, clean mounting faces and ensure screws are torqued correctly to prevent loosening under load.

Will this alter ride height or shock geometry?

The tower itself does not change ride height, but you should remeasure shock lengths and suspension geometry after installation to maintain intended settings.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved