XRAY 305392 Drive Shaft Pin 2x10 with Flat Spot (2) - Compact CVD Pin  [XR-305392]

XRAY 305392 Drive Shaft Pin 2x10 with Flat Spot (2)
Price:
£7.19
Brand:
XRAY
Model:
XR-305392
Condition:
Brand New
Write a review

Upgrade Your Drive Shaft Link

The XRAY 305392 Drive Shaft Pin, 2x10mm, offers a compact solution for stabilising CVD linkages. The machined flat spot gives the setscrew a positive point to clamp against, helping to minimise loosening during hard use.

Benefits for Track and Trail

This pin is manufactured to accurate dimensions so it seats consistently and supports repeatable setups. The enhanced setscrew contact reduces the chance of drift in the drive train, which is important for consistent handling.

Installation and Use

These pins work well in applications calling for a 2x10mm part and are suitable for both racing setups and general maintenance. Fitting is straightforward and yields a noticeable improvement in retention over smooth pins.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How can I tell if my setscrew is engaging the flat spot?

Loosen the setscrew and slide the pin slightly to observe alignment, then tighten lightly and check that the screw head sits against the flat area rather than a rounded surface.

Is any special tooling required to fit XRAY 305392?

No special tools are needed beyond the correct hex or allen driver for your setscrew; careful hand torque and a quick post-run check are sufficient.

Should I replace both pins at the same time?

Replacing pins in pairs is a good practice to maintain balanced wear and consistent fit across the drive shaft assembly, especially for competition cars.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved