XRAY 323353-G Rear Upright Graphite Composite Precision Fit  [XR-323353-G]

XRAY 323353-G Composite Upright Rear - Graphite
Price:
£9.52
Brand:
XRAY
Model:
XR-323353-G
Condition:
Brand New
Write a review

Precision Graphite Rear Upright for Better Handling

The XRAY 323353-G upright is produced from a tuned graphite composite to deliver a stiff, light rear hub solution. Built for left and right sides, it enhances rear-end stability and gives drivers more confidence when pushing on high-grip surfaces.

Engineered for High Grip Racing

This component is targeted at high- and very-high-traction conditions where reliability and consistent cornering are required. Multiple upper roll centre options let you tailor rear behaviour to suit track characteristics.

Key Mechanical Details

Featuring a 0 degree toe layout, the upright keeps suspension geometry steady under load, and the set screw hole helps lock the pivot pin securely. External 5x12mm bearings and smaller internal 5x10mm bearings combine durable drivetrain support with lower unsprung mass.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What setup changes should I try first?

Start by testing different upper roll centre positions to find the best balance between turn-in and mid-corner stability, then fine tune camber and swaybar settings.

Will this part reduce rear snap under power?

On grippy surfaces the stiffer graphite uprights can reduce sudden oversteer by stabilising rear geometry, but final behaviour depends on the full setup and tyre choice.

How do I check for wear after crashes?

Inspect the uprights for hairline cracks around mount points and check bearings for play; replace if there is visible damage or looseness to maintain safe handling.

Can I run these uprights with oversize bearings?

The design is specified for external 5x12mm and internal 5x10mm bearings. Fitment of other sizes is not recommended without confirming clearances and hub compatibility.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved