XRAY 352322 XB808 Rear Aluminium Suspension Holder - Performance  [XR-352322]

XRAY 352322 XB808 Aluminum Front Lower Suspension Holder - Rear - Swiss 7075 T6 (7mm) - Hard Coated
Price:
£24.52
Brand:
XRAY
Model:
XR-352322
Condition:
Brand New
Write a review

Durable Rear Suspension Holder for the XB808

The XRAY 352322 XB808 Aluminum Front Lower Suspension Holder is tailored for the rear location of the front bulkhead on the XB808 chassis. CNC-machined from 7mm Swiss 7075 T6 aluminium, it provides excellent structural strength suited to competitive environments. The hardcoated finish improves scratch and wear resistance for consistent performance.

Front Roll Centre Fine-Tune with I.S.S.

Equipped with the XRAY I.S.S. system, this holder allows roll centre settings from -1mm to +1mm to help balance steering and stability. Included reinforced bushings enable 1 degree and 0.5 degree eccentric adjustments for refined front kick-up control.

Machine Accuracy and Official Marking

Manufactured on automated German CNC machines, this component is made to tight tolerances for accurate repeatability. XRAY applies hardcoating in-house and laser engraves each item to confirm its origin and quality.

Specifications

  • Material: Swiss 7075 T6 Aluminum
  • Thickness: 7mm
  • Adjustability: Roll center geometry (-1mm, 0mm, +1mm)
  • Bushing Eccentricity: 1° and 0.5°
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this a direct replacement for the stock part?

Yes, it is designed as a direct-fit upgrade for the XB808 front bulkhead area and replaces the standard front lower suspension holder without alteration.

Which settings should I try first on a new track?

Start with the neutral 0mm roll centre and the standard bushing position, then move to -1mm or +1mm in small steps while checking understeer and oversteer responses.

Any special tools needed for installation?

Basic RC workshop tools and a torque driver for consistent screw tightening are sufficient. Follow XRAY assembly guidance for correct torque settings.

Copyright © 2008-2025 rcjaz.co.uk All rights reserved