XRAY NT1 Titanium Turnbuckle Link Set XN1-39 by 3Racing  [XN1-39]

Turnbuckle kit for the NT1 platform

This turnbuckle kit is intended for the XRAY NT1 chassis and provides replacement suspension and steering linkages with a titanium finish. It is offered as a compatible alternative to standard steel or aluminium turnbuckles; verify fitment against your NT1 ball ends and rod ends before fitting.

Tuning role: turnbuckles allow precise adjustments to toe and camber link length and can tweak roll behaviour on 1/10 touring cars. Titanium-finish links support stable threaded settings so alignment stays consistent through sessions.

Fitting guidance: match the left and right thread directions for the NT1 and use the correct hex key for your ball and rod ends. Apply a firm hand torque and check for full steering and suspension travel after installation. When swapping matched-length links, change settings incrementally while checking alignment at front and rear.

Maintenance notes: the titanium finish helps reduce corrosion compared with untreated steel, but inspect threads periodically and apply thread-locker only where permanent locking is required. Keep ball ends clear of grit to prevent accelerated wear.