XRAY T4 53mm BB DJC Precision Block by Arrowmax AM-010071  [AM-010071]

BB DJC 53mm bearing block for XRAY T4 chassis

The Arrowmax AM-010071 BB DJC is a 53mm bearing block designed to suit XRAY T4 linkage layouts. This aftermarket component is produced to interface with 53mm ball arrangements and to act as a direct replacement where BB DJC form is needed.

Its role in setup is to locate ball ends, keep correct spacing between link elements, and it can affect steering geometry and roll centre characteristics when altered during tuning. Confirm your XRAY T4 link measurement is 53mm before fitting to avoid misalignment.

Installing the block follows standard T4 linkage procedures: remove the existing item, transfer any required studs or bearings, and secure fastenings to the chassis specification. No special tools beyond usual hex drivers are required. Once fitted, run the steering through full travel and recheck geometry and clearances.

Use this BB DJC block to match 53mm linkage geometry on XRAY T4 models; treat it as a precision replacement and verify steering and suspension clearance after swap.