XRT 8S Stainless Chassis Plate Kit XRTZSP1A XRTZSP1 for TRAXXAS by GPM  [XRTZSP1A]

Lower chassis armour for TRAXXAS XRT 8S

This chassis plate set from GPM fits the TRAXXAS XRT 8S platform, reinforcing the front, centre and rear underside areas of the model. Each shield is fabricated from 304 stainless steel to give corrosion resistance and abrasion protection where the stock chassis typically contacts rough ground.

Plates are hand polished and subject to quality checks to ensure flat mating faces and correct alignment with the stock chassis. Installation is non destructive and designed to use the original mounting points on the vehicle, with the supplied fastening hardware used to secure the plates. The kit is supplied for direct attachment to the factory chassis using the recommended screws.

On the trail this plate set shields vulnerable underside sections, reduces edge wear from strikes, and helps preserve chassis flatness under repeated loading. It does not modify suspension geometry or drivetrain setup and is intended solely as a protective structural reinforcement for the scale RC model.

Install to protect and stiffen the XRT 8S underside without changing the stock layout, and recheck fastener torque after initial runs.