YOKD173 Front FCD Gear for Dirft Package Series Front One-Way/Solid Axle by Yokomo  [YOKD173]

Yokomo D-173 - FCD gear (Front x 0.59) for Dirft Package Series Front one-way/Solid axle
Price:
£18.80
Brand:
Yokomo
Model:
YOKD173
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DP category
Write a review

Direct-fit front FCD gear for Dirft Package builds

This Yokomo front FCD gear is intended as a direct-fit replacement for the Dirft Package Series front one-way and solid axle assemblies. With a 0.59 ratio marking, it is offered as a drivetrain spare to restore or modify front transmission response on drift-oriented RC cars.

The component interfaces with the package's front one-way unit or a solid axle layout, giving technicians a simple option to replace worn parts or alter front-end drive behavior while configuring a drift setup.

Fitting guidance: remove the front differential or one-way module, clean mating areas, inspect bearings and spacers, then install the gear ensuring proper mesh and axial clearance. Carry out hand-rotation checks before powered trials.

Setup impact: exchanging this gear is a targeted change to front drive ratio and torque transfer; couple the swap with suspension and tyre adjustments to achieve the desired slide and balance characteristics.

Specifications

  • Item: FCD gear (Front x 0.59)
  • Material: Not specified
  • Model Number: YOKD173
  • Compatibility: Dirft Package Series Front one-way/Solid axle

Use this gear when replacing a worn front FCD or when altering front transmission ratios within the specified Dirft Package Series assemblies; always verify fitment before track use.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which front configurations are supported?

The gear is listed for use with the Dirft Package Series front one-way and solid axle configurations. Confirm your chassis uses one of these front assemblies before purchase.

Will this require shimming adjustments?

After installation, check gear backlash and axial alignment. Minor shimming may be necessary to achieve optimal mesh and noise-free operation.

Can I use this gear for setup trials?

Yes. Swapping to this 0.59 gear is suitable for controlled tuning trials to observe changes in front torque delivery and handling characteristics.

What should I inspect after a few runs?

After initial runs, recheck gear mesh, bearing condition, and any retaining hardware. Address any abnormal wear or noise before further high-speed use.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved