Yokomo B8-RTC-12 Rear Suspension Arm for BD8 2018 RTC  [B8-RTC-12]

Yokomo B8-RTC-12 RTC Rear hard sus arm(54mm-40.5mm Graphite molded) for BD8 2018
Price:
£3.80
Brand:
Yokomo
Model:
B8-RTC-12
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision rear arm for BD8 RTC applications

This graphite molded rear hard suspension arm is produced for the optional RTC (Rear Toe Control) configuration on BD8 2018 chassis. It conforms to BD8 2018 rear geometry, featuring a 54mm in/out suspension pin spacing and a 40.5mm shock pivot.

Choose this arm when you require a more rigid rear link to limit hub flex and maintain toe settings during heavy loads. It replaces the stock rear arm and works alongside RTC components to permit more precise toe adjustment without modifying other suspension geometry.

Setup tips: a harder rear arm will usually crisp up turn-in and can raise lap-to-lap consistency on high-traction surfaces while increasing the rear's tendency to snap on loose layouts; after installation check roll centre and shock angle and use the original mounting hardware unless the RTC kit indicates otherwise.

Compatibility

  • BD8 2018
  • MRTC-BD818
  • MRTC-BD818A
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this arm fit without modifying the chassis?

Yes. The arm is designed to mount to the BD8 2018 rear points and should install without chassis modification when used with compatible hardware.

What effect does this have on toe adjustment range?

When used with the RTC system the arm enables finer toe settings, improving precision without altering other suspension geometry.

Should I inspect anything after a race weekend?

Inspect the arm for signs of wear around mounting holes and confirm the shock pivot and roll centre remain unchanged; replace any worn fasteners as required.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved