YOKOMO BD5 BD7 Rear Swing Shaft 44mm YO-02 service replacement by 3Racing  [YO-02]

YOKOMO BD5 / BD7 Rear Swing Shaft 44mm - 3Racing YO-02
Price:
£13.01
Brand:
3Racing
Model:
YO-02
Condition:
Brand New
Write a review

Rear swing shaft for BD5 and BD7 maintenance

This YO-02 44mm rear swing shaft is a direct-fit service replacement for YOKOMO BD5 and BD7 1/10 touring car chassis, intended to replace worn rear linkage shafts during maintenance or rebuilds.

The shaft acts as the rear suspension pivot, contributing to correct wheel alignment and suspension geometry that influence handling characteristics. Confirm BD5 or BD7 compatibility on your chassis prior to ordering.

Fitting a new shaft restores repeatable pivot motion and reliable rear suspension behaviour, supporting consistent setup and tuning without modifying spring or damper rates.

Specifications

  • Item: Rear Swing Shaft
  • Model Number: YO-02
  • Length: 44mm
  • Compatibility: YOKOMO BD5, BD7

A neutral replacement part sold as a single shaft for routine rear suspension servicing and setup work.

Does this part fit other YOKOMO models?

This shaft is listed specifically for BD5 and BD7 fitment. It may not suit other models; check measurements and chassis codes before assuming compatibility.

How does the shaft affect suspension accuracy?

A fresh shaft eliminates play that can cause inconsistent geometry, improving repeatability and the accuracy of setup changes.

Should I replace both sides at once?

If one shaft shows wear, inspect the opposite side and consider replacing both to maintain symmetrical suspension behaviour.

Where can I find the model number?

The model number YO-02 is listed in the product specifications to help identify the correct replacement component for your chassis.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved