Yokomo B-MAX2 Steering Arm 25T by Arrowmax AM-MAX2-011  [AM-MAX2-011]

Arrowmax AM-MAX2-011 Servo Arm 25T (7075)
Price:
£9.38
Brand:
Arrowmax
Model:
AM-MAX2-011
Condition:
Brand New
Write a review

Machined 25T aluminium horn

The Arrowmax AM-MAX2-011 is a machined 7075-T6 aluminium servo arm with blue anodize, offered as a direct replacement for the Yokomo B-MAX2 plastic horn. It maintains the standard 25-tooth spline interface while delivering increased stiffness.

Fitting is straightforward: remove the original horn, centre the servo, fit the AM-MAX2-011 on to the 25T spline until fully seated, and refit the original retaining screw. The arm profile is cut to suit the B-MAX2 steering geometry, avoiding extra trimming in most installations.

In service the higher-strength alloy reduces deformation under load, helping sustain consistent steering feedback during fast cornering and transitions. After swapping in the aluminium arm, verify and adjust steering end-points and trim so the servo centre and travel match the chassis setup.

Does this replace the original plastic arm exactly?

Yes, the AM-MAX2-011 is made to directly replace the stock 25T plastic horn on the B-MAX2 without altering mounting points.

Will using aluminium void any warranty?

Aftermarket upgrades like this are not OEM parts; check the vehicle manufacturer warranty terms, as fitting non-original parts can affect warranty coverage in some cases.

How much improvement in steering should I expect?

Improvement depends on the condition of the original horn and overall setup, but most users see firmer steering feel and more consistent feedback, especially if the plastic part was worn or flexing.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved