Yokomo FA-19218 jp FANTOM Hall sensor replacement board  [FA-19218]

Price:
£27.77
Brand:
Yokomo
Model:
FA-19218
GTIN:
639342200832
Condition:
Brand New
Write a review

FANTOM sensor replacement details

The Yokomo FA-19218 jp is a replacement Hall sensor PCB for FANTOM-series brushless motors. It provides the position sensing module used by HELIX and ICON family motors and is designed for rotors of 24mm or 25mm diameter. This part is intended for RC motor servicing to restore sensor-based commutation feedback.

Coverage includes HELIX, HELIX V2, ICON V2, ICON V3 and ICON-Torque FANTOM variants, with compatibility for 24mm and 25mm rotors. Verify rotor diameter and motor variant before installation to ensure correct fit and signal timing.

As a repair component, the board restores the sensor feedback the ESC relies on and is not marketed as a performance upgrade. Technicians should check connector condition and internal clearances and confirm sensor orientation aligns with the original assembly.

Specifications

  • Item: Replacement sensor board for FANTOM motor
  • Model Number: FA-19218 jp
  • Compatibility: HELIX, HELIX V2, ICON V2, ICON V3, ICON-Torque
  • Rotor Size: 24mm and 25mm

Compatible Models

  • FA-19117ST
  • FA-19221ST
  • FA-19013ST
  • FA-19017ST
  • FA-19021ST
  • FA-18613ST
  • FA-18617ST
  • FA-18621ST

This PCB is suitable for restoring sensor function in FANTOM motors fitted to the listed Yokomo chassis, maintaining consistent sensor feedback for everyday running and setup; confirm rotor size and motor family before fitting and follow standard motor servicing precautions.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does FA-19218 jp work specifically with ICON-Torque models?

Yes. ICON-Torque is listed among the supported FANTOM variants alongside HELIX and ICON V-series models.

What installation checks should I perform before reassembling the motor?

Verify internal clearances, inspect connector pins for damage, and confirm the replacement PCB is oriented and seated as the original to preserve correct sensor phasing.

Are the listed chassis codes definitive for compatibility?

The product provides several Yokomo chassis codes including FA-19117ST and FA-19221ST. Use that list to check whether your specific chassis is referenced for fitment.

Will replacing the sensor board require ESC firmware changes?

In most cases, no firmware change is needed; the ESC will use the restored Hall signals. After installation, verify commutation and low-speed behavior and adjust ESC settings only if irregularities are observed.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved