Yokomo FA-19219 FANTOM Motor Sensor Board Replacement - HELIX/ICON Compatible  [FA-19219]

Price:
£27.77
Brand:
Yokomo
Model:
FA-19219
GTIN:
639342200849
Condition:
Brand New
Write a review

Replace the FANTOM sensor module to regain feedback

This replacement sensor board is intended for the FANTOM motor family and fits motors designed for a 26mm rotor. It delivers the sensor interface required for sensored operation with HELIX, HELIX V2, ICON V2, ICON V3 and ICON-Torque motor variants. The board's function is to restore rotor position feedback used by sensored ESCs, not to modify mechanical motor attributes.

For installation, match the board to the exact motor variant and carefully align connector pins with the motor harness; confirm orientation and connector type prior to applying power. As a component-level interchange, inspect solder joints and connector integrity on both motor and ESC, and handle the board in an ESD-controlled environment.

The sensor board will not change motor power or top speed; it ensures precise feedback for ESC control. If faults persist after replacement, inspect ESC sensor configuration and motor timing rather than undertaking additional mechanical repairs.

Specifications

  • Item Sensor board replacement for FANTOM motor, for 26mm rotor motors
  • Material Not specified
  • Model Number FA-19219
  • Compatibility FANTOM motors used with HELIX, HELIX V2, ICON V2, ICON V3, ICON-Torque; supported chassis FA-19113S, FA-19117S, FA-19221S, FA-19013S, FA-19017S, FA-19021S, FA-18913, FA-18917-6

Choose the Yokomo FA-19219 when replacing a defective sensor board in a sensored FANTOM motor to restore dependable rotor position feedback, and follow with sensor validation and ESC setting checks.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What compatibility checks should I do before ordering FA-19219?

Confirm your motor is a FANTOM variant with a 26mm rotor and verify the motor connector type and part numbering to ensure FA-19219 matches the installed hardware.

If the motor still misbehaves, where should I look next?

Inspect connector continuity, solder joints and ESC wiring. Run ESC sensor diagnostics and confirm timing values before replacing other components.

Which chassis list FA-19219 support?

The board is compatible with FANTOM-equipped chassis including FA-19113S, FA-19117S, FA-19221S, FA-19013S, FA-19017S, FA-19021S, FA-18913 and FA-18917-6 as specified.

Is soldering typically required to fit this replacement?

Some motors use plug-in connectors and require no soldering; others may need desoldering and reflow of small joints. Inspect the motor's connection type to determine tool requirements.

How should I handle suspected board faults after fitting?

Run sensor diagnostics, check for consistent three-phase signal pulses, and swap the board back to bench-test against a known-good ESC to isolate the issue.

Will this replacement alter motor performance characteristics?

No. The FA-19219 restores sensor feedback only; mechanical power, torque and top speed remain unaffected. Any performance change points to ESC or timing adjustments.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved