Brushless Sensor Lead 200mm for RP - Yokomo YOKRP-012  [YOKRP-012]

Yokomo RP-012 - Racing Performer 200mm Sensor Wire for RP
Price:
£4.61
Brand:
Yokomo
Model:
YOKRP-012
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Compatibility and wiring for RP motors

The Yokomo YOKRP-012 Racing Performer sensor wire is intended as a replacement or extension cable for RP-series sensor-equipped brushless setups. Its 200mm length provides a neat, measured option for internal runs between a sensorised motor and an ESC or junction in touring, drift, or competition electric cars.

Fit this lead when you need a consistent cable length to simplify installation and wiring tidiness. Keep the sensor lead routed away from battery and power lines to reduce interference, secure it with ties or clips to prevent movement, and avoid tight bends close to solder joints. Trim surplus only after confirming final component layout to maintain signal quality.

Installation notes: follow chassis routing channels where possible, cover soldered joins with heat-shrink to prevent shorts, and check connector orientation before completing assembly. The wire itself is passive and will not change electronics or motor parameters, but secure sensor connections are important for smooth brushless commutation.

Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which motors or ESC setups is this compatible with?

It is designed for sensor-equipped brushless motors that use the same style of sensor connector; confirm the connector type on your motor and ESC or junction before installing.

What steps should I follow when replacing a damaged sensor lead?

Route the new lead along established chassis channels, solder or fit connectors securely, cover joins with heat-shrink to prevent shorts, and verify connector orientation and signal continuity before powering up.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved