Yokomo SD-415R10A R. Hub Carrier 1 Degree Compatible with DP-series and MRTC [SD-415R10A]

Price:

£4.96

Brand:

Yokomo

Model:

SD-415R10A

GTIN:

0639342189397

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
Spares / Hop-ups - Yokomo - DP-DPRA category

Write a review

Description
FAQ

Drift rear hub replacement

This rear hub carrier is intended as a direct replacement for drift-package RC models and establishes the 1 Degree rear orientation used in drift setups. It is supplied as matching left and right units so you can swap a damaged carrier without modifying axle or upright geometry.

Compatibility is specific to the chassis listed below. Installation follows a simple replacement procedure: remove the damaged unit, move over any bearings or spacers if required, and refit with the factory hardware while checking bearing alignment and wheel clearance. Use this component to recover original handling or to make small adjustments to rear tracking.

Packing includes

Rear hub carrier R - 1 pcs
Rear hub carrier L - 1 pcs

Compatible Models

DP-DP8
DP-DPMS
DP-DPRA
DP-DPRH
DP-GR35
DP-UF86A
DP-M786A
DP-HKS86A
DP-MKXA
DP-C33A
DP-SC430A
DP-TY180A
DP-JZX2A
DP-BNAA
DP-SDA
DP-TSFCA
DP-EVXA
DP-DKPA
DP-BS15A
DP-REA7A
DP-C35A
DP-DM13A
DP-GDBFA
DP-ZCRA
DP-1093A
DP-TYS15A
DP-BL34DA
DP-B324RA
DP-SR86A
DP-PS13A
DP-TRS15A
DP-JZZ30A
DP-DR86A
DP-REAA
DP-ORCZ33A
DP-GDBA
DP-JZXA
DP-KOS15A
DP-IS220A
DP-TSS15A
DP-BLR34A
DP-APEXA
DP-HKSA
DP-180SXA
DP-FC3SA
DP-S15A
DP-AE86A
DP-DRG3
MRTC-SD9
MRTC-86
DP-DRG3G
DP-N86R
DP-N86W
DP-N15R
DP-N15W
DP-N15S

Remark :

Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which chassis codes will accept this carrier?

Refer to the full compatibility list in the section above; the carrier fits only the listed DP-series and MRTC codes, so check your chassis designation before ordering.

Will fitting require axle modification?

No axle modification is required for standard installs. The carrier is designed to swap in using the original hardware, though you should transfer bearings or spacers as needed and confirm clearance.