YS Engine YSG7040 DZ70 Replacement Push Rod for DZ70 Series  [YSG7040]

YS ENGINE PUSH ROD DZ70 #G7040
Price:
£4.25
Brand:
YS Engine
Model:
YSG7040
GTIN:
4562101335956
Condition:
Brand New
Write a review

Service push rod for DZ70 engines

This YSG7040 push rod is intended as a single service replacement for YS Engine DZ70 glow engines to restore correct valve actuation and linkage performance.

Install a new push rod when the original is bent, worn at the ends, or shows excessive play that affects valve timing. The push rod transfers rocker or cam movement to the valve lifter, so correct length and straightness are required for consistent operation and proper valve clearance setup.

To install: remove the rocker retention hardware, withdraw the worn rod and fit the YSG7040, then reassemble and confirm valve clearance and unobstructed movement through the full travel range. Verify smooth operation and correct clearances before running the engine.

Compatibility: For DZ70 series YS RC glow engines.

Does this replacement match the factory part number?

The YSG7040 is offered as a replacement designed to match the original DZ70 push rod's form and function for correct fitment within the valve train.

Are there tolerance differences to be aware of?

Manufactured to service specifications, users should still inspect the part for straightness and correct end geometry before final assembly to ensure it meets the engine's clearance and movement requirements.

Will fitting this part require valve timing readjustment?

After fitting a replacement push rod, always recheck and adjust valve clearance as necessary; even minimal variations can affect timing and should be corrected before running the engine.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved