YZ-2DTM Compatible 3G Transmission Case L/R - Z2-302D3M by Yokomo  [Z2-302D3M]

Yokomo Z2-302D3M 3G Transmission Case L/R for YZ-2DTM
Price:
£6.29
Brand:
Yokomo
Model:
Z2-302D3M
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Drive Train Parts category
Write a review

3G Transmission Case—Compatible with YZ-2DTM

Designed for the 2WD YZ-2DTM platform, this 3-gear transmission case provides the enclosure and mounting interfaces for the 3G gear train. It supports the driveline internals used on YZ-2DTM based chassis.

Replace worn or damaged transmission housings on compatible B-YZ2DTM family models with this left/right pair. The case is intended for standard RC maintenance and repair tasks where correct enclosure geometry affects gear mesh and drivetrain alignment.

When installing, check bearing alignment and seating, set correct gear mesh and freeplay before power-up, and inspect any seals or shims transferred from the original assembly. This unit is supplied as a direct replacement and not as a gear ratio changer.

Compatibility

  • B-YZ2DTM
  • B-YZ2DTMW
  • B-YZ2DTM2
  • B-YZ2CAL2
  • B-YZ2DTM2S
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this fit B-YZ2CAL2 models without modification?

The case lists compatibility with the B-YZ2CAL2 model among others. For peace of mind, compare mounting points and part references or confirm with the seller to ensure a direct fit to your specific chassis variant.

Does this part require different bearings or shims?

This housing is intended to match original bearing locations and shim arrangements. If you reuse seals or shims, inspect them for wear and replace if necessary to maintain correct mesh and bearing preload.

Is any setup needed after swapping housings?

Yes. After swapping housings, check alignment, set gear mesh, confirm smooth rotation by hand, and perform a cautious test run while monitoring for unusual noise or binding.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved