YZ-2 Compatible Rear Suspension Mount Spacer - Yokomo Z2-300RSA  [Z2-300RSA]

Rear mount spacer designed for YZ-2 setups

This is an RC-scale rear suspension mount spacer intended for use with the Yokomo YZ-2 family. The spacer is placed between the plastic rear suspension mount pieces so you can achieve smaller, incremental changes to rear suspension arm height without modifying the original mounts.

Use the spacer to refine roll centre and ride height or to correct geometry after swapping mount plates. It stacks with the factory plastic components and provides a predictable offset rather than replacing existing parts. Make measured adjustments and reassess handling after each change.

Fitting is simple: loosen or remove the rear mount as required, position the spacer between the plastic mount layers at the chosen point, then reassemble and check alignment. As this part is for fine tuning, perform incremental changes and verify suspension travel and wheel clearance before high speed operation.