Graphite Steering Block Plate for YZ-2T, 0.5mm Offset - Z2-415T05A Yokomo  [Z2-415T05A]

Yokomo Z2-415T05A Graphite steering block plate (0.5mm offset) for YZ-2T
Price:
£8.71
Brand:
Yokomo
Model:
Z2-415T05A
GTIN:
0639342216710
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Suspension Parts category
Write a review

Product brief: graphite steering block for YZ-2T

This graphite steering block plate is an RC replacement part made for the YZ-2T 2WD racing truck platform. Moving the tie rod pick-up 0.5mm rearward relative to the YZ-2CAL2 plate produces a milder initial steering input while maintaining a linear steering characteristic. The set is supplied with two pieces for left and right sides.

Install this plate when you aim to reduce initial steering aggression without sacrificing predictable feedback from the steering system. It is intended for mounting into the existing steering knuckle locations on compatible YZ-2T variants and should be fitted using the stock hardware for correct alignment.

Compatible Model List

  • B-YZ2DTM31-1
  • B-YZ2T
  • B-YZ2DTM2
  • B-YZ2CAL2
  • B-YZ2DTM2S
  • B-YZ2DTM3
  • B-YZ2CAL3
  • B-YZ2CAL31-1
  • SOR-010
  • ROR-010
  • ROR-010RTR
  • ROR-010RTR-1
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How will the 0.5mm offset influence corner entry?

The slight rearward relocation of the tie rod pick-up reduces the immediacy of steering input at corner entry, making the truck easier to place into the turn while keeping consistent mid-corner behavior.

What does the kit include and how many parts are provided?

The kit provides two graphite plates to fit both left and right steering knuckles, allowing symmetrical tuning of steering response.

Is this compatible with standard YZ-2T knuckles without modification?

Yes. It is intended to replace the original plate on the listed YZ-2T models and uses the same mounting points. Always check tie rod geometry and fastener torque after fitting.

Copyright © 2008-2026 rcjaz.co.uk All rights reserved